I can't seem to find the spacer specs for oversized rear idles (SRX 440 wheels) on a Viper. I need to get this done ASAP, does anyone know where that post is? I alerady checked the tech section and either missed it or its not there. Should also mention I'm running a 4 wheel setup, not the standard 3. Also the 4 wheel mod in tech section is for regular rear idlers, the SRX 440 ones use a slightly wider bearing.
Thanks,
Bruce
Thanks,
Bruce
Last edited:
Measure the short side spacer and cut one for the other side the same (from the middle spacer) Mic out the width of the bearing and cut that off what is left of the middle spacer and you should be set.
Last edited:
Ended up mic'en out. New bearig are 2mm wider the original. Cut 2mm of outside spacers, 1mm of short inside spacers and 2mm off center spacer. I'll try and post the finished measurements and have them added to the tech section.
PS - this only works after you've already done the 4 wheel mod from the tech section. Like I said, I'll try to post the actual measurements.
PS - this only works after you've already done the 4 wheel mod from the tech section. Like I said, I'll try to post the actual measurements.