badboy81
New member
cleaned my carbs,put it back together ran fine,cleaned my power valves,now it wont idle right.i know the valves are adjusted right cuz i stuck my hand up the cylinder and the valve is flush with the head with the servo in the open position.i think its only running on the 2 outside cylinders.all 3 get hot but the middle one,if you put your hand over the carb it still runs.if you do it to the other 2 carbs it kills the engine.also if you spray staring fluid in the outer 2 the engine revs up,if you spray it in the center one it bogs out.all 3 have good spark and good plugs.any ideas what it could be?thanks
daman
New member
its nothing you did with the pv's,pull carbs check er out,check reeds,make sure all carb slides are moving up/down,,
1 spark
2 compression
3fuel
should run..
1 spark
2 compression
3fuel
should run..
badboy81
New member
ya took the carbs off again everything looked fine,all had gas in themchecked the reeds those were good too.gona do a compression test tomorrow...
daman
New member
.......daman said:make sure all carb slides are moving up/down,,
no1chevyboy
New member
check choke on center carb