Driveshaft bearing size 84 phazer

S

stinger440

New member
Joined
Dec 22, 2009
Messages
57
Age
46
Location
GR MI
I think this is the last wear part left on this machine. Anyway what size is the driveshaft bearing on the speedometer side? I have the OEM number but I would like to get the actual size or industry # 620... etc. Thanks in advance.
 
bearing

Are you asking for jackshaft bearing behind secondary clutch that goes into aluminum holder and held in place with cam lock/set screw? If so it is 25mm id bearing. The shaft od is 25mm (not 1"), the aftermarket bearing number is CSA205-25. Send me pm and I get get phone number to order. They are around $7.50 each compared to Yammy at around $70.
 
Acutally I am looking for the bearing on the track drive shaft behind the speedometer drive. Looks like 6022 2RS is the magic number so far.
 
80ccs said:
Are you asking for jackshaft bearing behind secondary clutch that goes into aluminum holder and held in place with cam lock/set screw? If so it is 25mm id bearing. The shaft od is 25mm (not 1"), the aftermarket bearing number is CSA205-25. Send me pm and I get get phone number to order. They are around $7.50 each compared to Yammy at around $70.
Click to expand...
Damn that would have been nice to know. I just replaced it.

And of course I damaged it trying to press / pound it in to the (also brand new) aluminum holder. I don't know why this needs to be a press fit, but it is.

Hopefully it holds up. I screwed up the seal on the bearing a bit, so I gooped grease around it to hopefully keep dirt out.
 
I am going to keep that jackshaft bearing number in my back pocket because I am sure that will be next.

Found the bearing 60/22 2RS Thanks for the help guys.
 
You must log in or register to reply here.


Back
Top