porting and shaving heads

yamalars said:
22,1 msv sounds high? I'm only got around 15 msv when i calculated my
stock -00 heads in this software, what am i doing wrong?

http://www.torqsoft.net/squish-velocity.html
Click to expand...

Torq soft always measured squish velocity lower than other softwares and lower than my TSR. I think its the way the torqsoft software is written or setup equation wise internally. Don't worry about it. I trust my TSR that's based off of Gordon P Blairs findings, etc.
 

mopar1rules said:
Torq soft always measured squish velocity lower than other softwares and lower than my TSR. I think its the way the torqsoft software is written or setup equation wise internally. Don't worry about it. I trust my TSR that's based off of Gordon P Blairs findings, etc.
Click to expand...
Ok thanks! Going to send my -99 heads out for machining soon so it's alot
of calc. going on now... Think i gonna aim at 13:1 cr. along with my
ported -00. That should be ok with our non alchohol (yet) premium fuel.
 
yamalars said:
Ok thanks! Going to send my -99 heads out for machining soon so it's alot
of calc. going on now... Think i gonna aim at 13:1 cr. along with my
ported -00. That should be ok with our non alchohol (yet) premium fuel.
Click to expand...

i would be a little leary about that. just my opinion.
 
You must log in or register to reply here.


Back
Top