Pto ???

[04VIPERS]

Took PTO off to grease my bearings. Is there a order in which the PTO go's back on?? or can I just put it back on.

 

[mopar1rules]

Took PTO off to grease my bearings. Is there a order in which the PTO go's back on?? or can I just put it back on.

what??

 

[valin]

Took PTO off to grease my bearings. Is there a order in which the PTO go's back on?? or can I just put it back on.

I apologize, but I am completely lost at that statement. Can you please better describe what you are considering a "PTO"? I would only assume you are referring to the primary and secondary clutches......

 

[Corey9965]

I'm not following your question. Your PTO shaft is the end of your crankshaft.

 

[04VIPERS]

secondary clutches??

Sorry I Fk up YES secondary clutches!!!!!

 

[mopar1rules]

don't grease anything on your clutches. assemble them dry.

 

[04VIPERS]

Just put the secondary clutches back on, any old way?? does it have to lined up or just stick it on an bolt it down?

 

[super1c]

Well the clutch that goes to the motor is the primary clutch. If you removed that then first torque the bolt to 85ft/lb then loosen and then retorque to 43ft/lb. If secondary put back on with washers as you took it off and torque to 46ft/lb. Good idea to check your offset also. Can do with a straight edge and a ruler. should be 15mm+/- 1mm. CCC

 

[04VIPERS]

got it thanks !!!