viperking
Active member
can anyone verify my jetting setup? I am building a 780 viper with hauck pipes and i contacted hauck and they gave me these specs
162.5 mains
50 pilots
vent line to airbox unhooked
fuel screws 2 1/2 turns out
needles in the 4th groove from the top with one shim above and one below on the center and pto cylinders and both shims below the clip on the mag side.
Can anyone confirm these settings? also i only have two 50 pilots so would i be ok to go up to a 52.5 pilot on one side and 50's in the other two or go with 52.5 pilots all the way across? Any info would be great thanks
162.5 mains
50 pilots
vent line to airbox unhooked
fuel screws 2 1/2 turns out
needles in the 4th groove from the top with one shim above and one below on the center and pto cylinders and both shims below the clip on the mag side.
Can anyone confirm these settings? also i only have two 50 pilots so would i be ok to go up to a 52.5 pilot on one side and 50's in the other two or go with 52.5 pilots all the way across? Any info would be great thanks