My 1999 SRX 700 have a new problem...#

F

Fleury_XLT

New member
Joined
Nov 29, 2010
Messages
25
Age
36
Location
Quebec,Canada
Hi ! Me again with my SRX !

Since I've repaired my intake, the performace is good, but yesterday a new problem appear. When I'm full throttle, it take something like 3-4 sec to happen, my engine sound like only two cylinders is working, and when I release throttle and I re-put it open wide, he give me all of is power until 3-4 sec, then he sound like before.

The performance is good (acceleration, hi speed ) until he start to do this.

Any Ideas ?
 
you could take your plug caps off and check the resistance, should be ~5k. Have you recently cleaned carbs? There's a set of wires that wears through from rubbing against the motor. Also up by the handlebars and by the left footwell CDI box. If none of that looks like it, maybe a bad CDI or stator.

What do your plugs look like? Could you take a picture and post it?
 
destey said:
you could take your plug caps off and check the resistance, should be ~5k. Have you recently cleaned carbs? There's a set of wires that wears through from rubbing against the motor. Also up by the handlebars and by the left footwell CDI box. If none of that looks like it, maybe a bad CDI or stator.

What do your plugs look like? Could you take a picture and post it?
Click to expand...

I'll check that tomorrow ! Can you tell me where are the T.O.R.S?
 
when its doing that (the problem) hold it there and hit the kill, then take a look at the plugs,see if there all burning the same. thats were i would start.
 
Ok I'll check for that... I had T.O.R.S on my 2006 yamaha Banshee, since that system has been remove, never had problem with it.
 
You must log in or register to reply here.


Back
Top