700 triple
New member
Hi, I was out for a ride and blew a belt, it ended up cutting the rad hose that runs under the clutches. i have 3/4 inch heater hose ready but can't get the hose off the front heat exchanger (too tight of a space). Any sugestions for removing the hose? Thanks
Last edited:
sleddineinar
VIP Member
If you can, take the primary off & secondary if you have to. Then you might have to slit it with a blade, if it is broken anyway, it doesn't matter.
700 triple
New member
Thanks, I just tried it again with a needle nose, I got a hold of the clamp but clutch was in the way so I couldn't get it off. I want to replace the whole hose. I think I will have to take the primary off to do it.
I also need front shocks... I found a set off a 02 viper. Does anyone know if they will work?
I also need front shocks... I found a set off a 02 viper. Does anyone know if they will work?
700 triple
New member
its all fixed now... kept the clutches on. took off the pipe and can to see it better(hole under motor), drained the anitfreeze, grabbed the clamp with a pair of needlenose vice grips and it came off. put it back together, added anitfreeze and just came inside from a little ride.