If I had all the parts I could take some detailed pics and do a short write up on that but I would need to find the old parts first. Its a real simple mod to do. I tested the grips with a car battery with a charger on it to see they would perform.Also used an ohm meter to keep the load within the factory specs as not to try to overload the stator. Not much use to have hot hands while being stranded on a trail somewhere.
If you do happen to use 07 bars they need to be wired in parallel. Meaning the yellow/red goes to one lead of each grip and the black to goes to the other lead of each grip.This keeps the load on the stator the same as the factory grips.
One thing to note on the 07 bars as well, they have the heating element mounted directly to the bars. All the heat is sucked up by the bars before it goes thru the rubber to your hands. I isolated the heating element by using some wire heat shrink tape. I removed the heating element from the bar and then I put the heat shrink tape on first and then the heating element and then the grip. This helps to insulated the heat sucking bars from the element. I also used sprayfoam in the bars. A trick a read up on that BETHEVIPER did.
As far as the risers go, thats just personal preference. The 06-07 bars have less of a step on them than the Viper,Srx or Sx.I believe the diff is somewhere around 2-4". I would need a set of old bars to measure that again to be sure. As you can see in my earlier post the total rise from top to bottom is 6". The was no need to change any cables but I did need to reroute the brake cable slightly to take the tension off of it while turning left.