80pantera said:Give turks(r.i.p) clutch set up in the tech pages a try. stock springs and wieghts. 4.5g rivets in both holes and a 53/43 helix. relatively inexpensive to try. I run this in my 600 runs to 8500rpm on the nose and pulls hard through out. cant give you a deffinet top speed ive only ran one real long lake pull. lake was snow covered at the time so speeds were down. did see 100 on the dream o. Im sure there was more left if conditions were better. It was enough to outrun an 800xcr and an F7 so i was pumped
SRX 600 stock motor? Hmm...
I knew it would be a bad idea to post that I out ran an 800 poo and an F7 with my itsee bitsee yammie 600 but the truth is I did. here's the reason why, I spent months in the garage working on my sled getting it set up right the polaris didn't get this attention because the owner don't care and the cat didnt get it because of time and money. everyone knows the value of maintanence and tuning and this just proves it. properly set up those sleds would eat me and I know that, but on this day on this lake I got the upper hand let me have my day in the sun will you lol
bADa$$ SRX
New member
alright i think i got this thing dialed in now. raced a 99 Mach 1 700 with 196 studs today, rolling starts, on ice, on snow, stopped starts. beat it everytime, we would be even until about 20 and then i would just walk away all the way up to 105 mph
also raced a 01 Polaris Edge 600, ported, piped, clutched and 144 studs, he beat me out of the hole but i would catch up and walk right past him
also raced a 01 Polaris Edge 600, ported, piped, clutched and 144 studs, he beat me out of the hole but i would catch up and walk right past him
It's great to hear you got it dialed in!! What did you end up doing to her?
What did you end up doing to her?
bADa$$ SRX
New member
set secondary wrap at 80 and added an engagement shim to the primary