Phazer Sync problems

B

Blackbird82

New member
Joined
Nov 7, 2011
Messages
4
Age
43
Location
Teulon, Manitoba Canada
I was having problems syncin my carbs on my 98 Phazer. When I would have them good and matched at a idle position at WOT they would be out. the far side would go past wide-open. Some people said online this is fine. Well I found that the carbs if they do this must have been moved on their bracketery. Took a screwdriver and loosened the brackets holdin them together. A little twist and u can watch the outside butterfly move!

All in all took some minor tweakin, but now it starts together and they end together.

Boo-ya.
Pete the John Deere Man
 
thats the exact same thing i found with my 88 i just bought. It is very sensitive to the brackets being twisted at all. I took my brackets off and tweeked them one at a time. Now i'm trying to figure out a tougher/stiffer front end to hammer trail with, any ideas? would a phazer 2 front be better?
 
You must log in or register to reply here.


Back
Top