can't remember if this was posted a V4.com but was is the peak torque for stock 800's and can someone post a picture of a dyno graph for the V-max 750-800
Thanks Andy
Thanks Andy
YAMMIEGOD3:16
Active member
8350 peak, but 8100 to 8450 is powerband. I DON,T KNOW HOW TO POST MY DYNO SHEETS. 3:16 (yammie tony)
how about foot lbs of torque #'s put down to the track 
Last edited:
YAMMIEGOD3:16
Active member
andy don,t know. mine on engine dyno only. 3:16
YAMMIEGOD3:16
Active member
thats showing around 142 at 8300 on a 97 800. my 1995 made 151 at 8350 at dyno-tech. good info ike. 3:16 (yammie tony)
I think that dynoed motor was fresh from the crate, and also different dyno´s different results. But it´s close enough that 150 hp mark.
Here is a ported, machined cylinderheads and Bender quads dyno results for 800 V4. Just over 180 hp on 9300rpm.
Ike
Here is a ported, machined cylinderheads and Bender quads dyno results for 800 V4. Just over 180 hp on 9300rpm.
Ike
Last edited:
YAMMIEGOD3:16
Active member
NICE TORQUE CURVE, VERY EASY TO CLUTCH. 3:16 (yammie tony)
I was going to say for a 2 stroke, that is one of the flatest torque curves I've seen.
Over 100 ft.lb is a lot of torque from a 2 stroke, that thing must be a beast on the lakes.
Over 100 ft.lb is a lot of torque from a 2 stroke, that thing must be a beast on the lakes.