kgwmu
New member
Hi, I am attempting to install a 06 Fusion IQ skid in my SRX. A little info on my sled, I have a long travel front end from a viper/sxr. Don't mind that my sled is far from ready to ride, I have a few things to finish up yet! 
Current location of front bolt hole, bolt sticking out of hole:
I used the JBshocks measurements for the Fusion skid. I got the front hole drilled and mounted, then I dropped my sled down to match the rear mounting hole on the fusion diagram. This would have the rear bumper sitting at about 20".The skid sits fairly flat but the front seems to still a little high. Is that how the skid is supposed to sit?
I want to mount the skid with it dropped out of the tunnel a little like I had with the CB drop brackets so the rear bumper sits about 22-23" tall. In the pics you can see where I want to mount the skid, but it doesn't sit anywhere near flat. How do I go about fixing that? Any advice would be great. Thanks!

Current location of front bolt hole, bolt sticking out of hole:

I used the JBshocks measurements for the Fusion skid. I got the front hole drilled and mounted, then I dropped my sled down to match the rear mounting hole on the fusion diagram. This would have the rear bumper sitting at about 20".The skid sits fairly flat but the front seems to still a little high. Is that how the skid is supposed to sit?

I want to mount the skid with it dropped out of the tunnel a little like I had with the CB drop brackets so the rear bumper sits about 22-23" tall. In the pics you can see where I want to mount the skid, but it doesn't sit anywhere near flat. How do I go about fixing that? Any advice would be great. Thanks!



Last edited: