SRX/Viper cages in a 96XT

A couple of bucks

A couple of bucks

VIP Member
Joined
Jan 17, 2009
Messages
6,386
Age
59
Location
Ogle County Illinois USA
Does anyone have any personal experiance with putting these in a twin. Was wondering about a 96 XT and a 2001 SX600R.

The following is a c & p from BTV.

You can add the viper/srx reeds to the twin cylinder sleds without modifying anything, they drop right in and by themselves help to unblock the boost port even without the notch.

http://www.totallyamaha.net/forums/...stion-about-reed-notch?highlight=reed+stopper
 
Last edited:
I put these in my 98 600 twin xtc and they were perfect fit. I did the reed stopper notch also because the viper stoppers have a bit more meat on them and wasnt worried about them breaking. Not sure if it was a big improvement as i never rode sled before but it was sure snappy! And for a 600 hauled the mail after with a turk clutch set up. Here is my post http://www.totallyamaha.net/forums/threads/88678-My-ditch-banger-project!/page3
 
Ok here's the update on the SX500R. Got the SRX/Viper reed blocks in there w/ a mild notching on the stoppers. It got rid of a very small amount of 0-1/4 throttle bog. But mid range and top end were fantastic. Noticeably better than before. Now what do I need to turn to eliminate that pesky bog off the line.I do have four of the .04 shims recommended in this post.....http://www.totallyamaha.net/forums/...-mod-question-with-picture?highlight=.04+clip

Or do you think it's a fuel screw adjustment?
 
You must log in or register to reply here.


Back
Top