Snowman74
Member
Ok decided to get a build thread going on my project. This started in February and is on going.
I bought it as a mountain mod: 700 bender porting, bender pipes, ekholm tunnel, ekholm 151 skid, egts, team tss98, light weight clear hood, mpi light weight trailing arms, aluminum control arms, boss seat, & 50hp shot of NOS. Others that I can't remember I'm sure.
I also picked up a red one for parts. That had a pro xr skid, iq dragon seat, blown hauck 900 motor, aluminum control arms, pro xr running boards & pro xr cooler.
Went out on my maiden voyage after stealing the jetting and clutching from the 900 so I had something for low altitude. Track was ratcheting bad, went to tighten the track and adjustment was maxed. Pulled the skid and found it was bent up pretty bad. Had a ride planned for a week away so decided to swap the motor into the red short track.
Also installed 8 tooth antiratchet drivers to fit a 1.75 back country track and put on the mountain skis. After a little tweaking on the jetting I was feeling pretty good about the ride.
Track rubs the pro xr cooler, jetting was a bit rich, clutching needs improvements, and just some general tweaking is needed.
Since I had no use for the mountain mod I parted it out.
Now I'm in the process off doing more changes. Bought a blue painted hood with ghost flames, skulls, & screaming faces. Putting on a lower profile U cooler. Installing a heel clicker primary. Installing the boss seat, mpi trailing arms, fox floats, primer, atacc, egts, coolant temp, and general tweaking.
I bought it as a mountain mod: 700 bender porting, bender pipes, ekholm tunnel, ekholm 151 skid, egts, team tss98, light weight clear hood, mpi light weight trailing arms, aluminum control arms, boss seat, & 50hp shot of NOS. Others that I can't remember I'm sure.
I also picked up a red one for parts. That had a pro xr skid, iq dragon seat, blown hauck 900 motor, aluminum control arms, pro xr running boards & pro xr cooler.
Went out on my maiden voyage after stealing the jetting and clutching from the 900 so I had something for low altitude. Track was ratcheting bad, went to tighten the track and adjustment was maxed. Pulled the skid and found it was bent up pretty bad. Had a ride planned for a week away so decided to swap the motor into the red short track.
Also installed 8 tooth antiratchet drivers to fit a 1.75 back country track and put on the mountain skis. After a little tweaking on the jetting I was feeling pretty good about the ride.
Track rubs the pro xr cooler, jetting was a bit rich, clutching needs improvements, and just some general tweaking is needed.
Since I had no use for the mountain mod I parted it out.
Now I'm in the process off doing more changes. Bought a blue painted hood with ghost flames, skulls, & screaming faces. Putting on a lower profile U cooler. Installing a heel clicker primary. Installing the boss seat, mpi trailing arms, fox floats, primer, atacc, egts, coolant temp, and general tweaking.
Last edited:
