Sxviperrules99
New member
I want my sled to just lift the skis all day! Any suggestions on how I can do this? I'm not worried about losing top end. What clutching and gearing should i use?
Thanks,
Thanks,
How do I get my Sx viper to wheelie!
- Thread starter Sxviperrules99
- Start date
unhook the front limiter straps and it will stand on the rear bumper all day long.......
devinzz1
Active member
^^^pulled apart a front shock doin that.
Sxviperrules99
New member
Ya, no way i'm doing that... i've already loosened her as much as she'll go. Any recommended gearing ratios?
Take your limiter straps out and make your own a little longer. Will allow you to get more transfer. Or get a Ski doo skid. My 97 MXZ was great at standing on end.
devinzz1
Active member
Take the transfer rods off and replace with a strap
Sxviperrules99
New member
Ok, will do. Man i've seen your vmax on youtube. It stands straight up! it's wicked man! Whatcha got for a track on that thing?
devinzz1
Active member
1 7/8" snocross track. Removing the rods will uncouple the skid completely. Mpi used to make a kit for about $50 which was just a strap and a couple spacers for where the rods used to be. NOTE: i havent done this and its really meant for the long track guys but it should wheelie theres no doubt about that.
Sxviperrules99
New member
Ok, I just went on mountain performance website and found that kit you were talking about for 50$. It does say that it's meant for long track sleds. Should I a take the chance anyway?
devinzz1
Active member
Like i said i havent actually tried it myself. Obviously trailability will be much worse but you could always put the rods back on. I swapped out the skid before i fooled around with them to much.
viperhauck
Member
Monoshock and some extra power 
http://youtu.be/yHgjkDMuLmw
http://youtu.be/yHgjkDMuLmw
devinzz1
Active member
^^^ when he says "some" he means a big bore bult motor and pipes.
Sxviperrules99
New member
Monoshock and some extra power
Where could i find a mono? I've looked everywhere!
viperhauck
Member
In that clip its a oem 700 with bender porting and cpr pipes. Also bored carbs
Sxviperrules99
New member
And I know man, That viper hes got is nuts, I've watched his videos hundreds of times!
viperhauck
Member
devinzz1
Active member
Sled scrap yards or from people parting out sleds. More popular skids to swap are doo scIII (and new) and polaris edge skids (what i have)
Sxviperrules99
New member
Haha its even better with 1000cc
Haha, ya man... Whatcha got for gearing in that beast?
viperhauck
Member
Its 23-40 with 8thoot drivers. Its a little low but its ok