kgwmu
New member
Hi guys,
I'm right in the middle of switching my track out and in doing so I have to change the drivers from 9T to 8T. I have the press and I've already removed the 9T, I marked where they were but I have 2 issues I am running into since the 8T drivers are thinner (in the area that mounts on the drive shaft).
1. How do I make sure I have the drivers located in the correct position left to right? The chain case side has to have more length left over than the clutch side, but I don't know how much.
2. One of the outside drivers is loose enough that I can slide it by hand, is there a way to fix that or do I need to get a new one
*I just realized I don't have the collars that are supposed to be on located on the outside of the outer drivers...shouldn't I have them? I've been running my sled for the last 8 years this way and never seemed to have a problem.
I'm right in the middle of switching my track out and in doing so I have to change the drivers from 9T to 8T. I have the press and I've already removed the 9T, I marked where they were but I have 2 issues I am running into since the 8T drivers are thinner (in the area that mounts on the drive shaft).
1. How do I make sure I have the drivers located in the correct position left to right? The chain case side has to have more length left over than the clutch side, but I don't know how much.
2. One of the outside drivers is loose enough that I can slide it by hand, is there a way to fix that or do I need to get a new one
*I just realized I don't have the collars that are supposed to be on located on the outside of the outer drivers...shouldn't I have them? I've been running my sled for the last 8 years this way and never seemed to have a problem.
Last edited: