
bluemonster1
LIFE MEMBER ONLY ONCE!!!
Brought the old girl in the garage this evening to get it ready to ride.Like usual cleaned the carbs good.Pulled the PV's out and to my surprise they were very clean from last season.I have been running Yamalube and seems to be fine.Got them adjusted properly.The PV cables are still holding up,compared to a few season's back where my PV's that were machined with stainless steel ends were cutting the cables on the slot .There is no such thing as a pull through anymore which is excellent.
BUT want to give a WARNING to ALL of you guys who has PV ends done with SS by Yamahead.Check that the SS bolt doesn't start to unscrew from the valve.One of my valves had the SS bolt backing out.So I red loctited it back in.This may cause disaster perhaps as it unwinds itself from the valve.
Got to change chaincase oil yet,put pipes back on and re pack the jackshaft and drive bearings and I am ready to go.The snow is starting tonight,so that is a bonus..
BUT want to give a WARNING to ALL of you guys who has PV ends done with SS by Yamahead.Check that the SS bolt doesn't start to unscrew from the valve.One of my valves had the SS bolt backing out.So I red loctited it back in.This may cause disaster perhaps as it unwinds itself from the valve.
Got to change chaincase oil yet,put pipes back on and re pack the jackshaft and drive bearings and I am ready to go.The snow is starting tonight,so that is a bonus..