Heelclickers 136 viper

mr viper will give you a set up, takes time. but youll be using red spring and 15.6mm rollers. going to need a shallow helix. 46 or 48 initial and 36-34 finish. probably a 34 finish because of the 136 you are running.
 
yammitrip1 said:
mr viper will give you a set up, takes time. but youll be using red spring and 15.6mm rollers. going to need a shallow helix. 46 or 48 initial and 36-34 finish. probably a 34 finish because of the 136 you are running.
Click to expand...

Yeah that's around what I was thinking too. I think we all owe this guy a beer for all the help he is around here! I'm still new on the site but after lots of research it's obvious we are lucky to have Mrviper!
 
you can try the 51/39 you have, usually if you dont know the angles for sure off a coded helix it makes it hard to get a differnt helix that will work because your likely working with the wrong information. It also matters as to what brand they are because they are all cut with differnt radius on the machine they are milled on when they are manufactured so some of them shift more agressively then others do. So again its hard to compare say a 50/40 dalton to a 50/40 bender they wont be the same rpm or the same shift between them.

I would certainly try what you have first.
 
Mr viper what do you recommend for heel and tip weight as a starting point. 5-6 grams in heel and 4-5 in tip?
 
You must log in or register to reply here.


Back
Top