Sxviperrules99
New member
Will this setup clear the tunnel with 8 tooth drivers? Or is there anything else I have to do?
Thanks,
Jake
Thanks,
Jake
Might rub a bit. Notch track where exchangers run. Some people just let the track wear itself in. Why not remove the protectors?
becuse the front heat exchanger protectors are welded in on a viper!
you can take a hacksaw or even a little die grinder and zip them things right off in the middle of a track swap. Can even use a chisel as well.
Yessir. Probably wouldnt use the chisle though.