needs help asap. adjusting powervalves on srx 700

auji700triple

auji700triple

New member
Joined
May 2, 2005
Messages
1,023
Age
38
Location
Labrador City,Canada
Having a little trouble figuring out how to adjust these powervalves on my 01 srx I have the heads off with the testing harness. I also have the servo cover off . I just need some guidance in figuring out how to get these suckers adjusted. This is the final step before j cna get coolant in this and fired up. Thx!!!
 
Yeah I searched the forums and found the tech section however... I'm a little confused. Do you open the valves fully then adjust them? Do they need to be adjusted to closed, meaning do I have to adjust them so they won't hit the piston or do they just go to closed potion? I'm guessing they only have one adjustment to fully open .
 
auji700triple said:
Yeah I searched the forums and found the tech section however... I'm a little confused. Do you open the valves fully then adjust them? Do they need to be adjusted to closed, meaning do I have to adjust them so they won't hit the piston or do they just go to closed potion? I'm guessing they only have one adjustment to fully open .
Click to expand...


I've only adjusted to fully open. I know in manual they give steps on how to adjust closed by feeling through exhaust port. But I've never had a problem with above link adjustment
 
they should never hit your piston. that would not be good. put them in slot, your heads are off so you should be able to see and adjust by useing your fingers. make sure valve is set all the way forward, if needs adjustment just loosing locknut on servo and adjust length. very easy to do. than tight,en nuts on servo. 3:16x (yammie tony)
 
You must log in or register to reply here.


Back
Top