ok boys and ladies i got a belt slippin problem on an et410 1997. was out riding with my brother and a buddy of ours on sat. we had bros viper my sxr and my et. we swapped out between the sxr and the et about 1/2 way through the run. when i was runnin the et on the way back home i noticed a belt squeal that would happen when i pushed the sled above 60kph. it would get louder as you pushed it to 80kph whitch is all it wanted to do at wot. the recently installed tac was holdin bang on at 6500rpm whitch is correct for this sled and engagement is at proper rpm too. primary spring was new beginning of this season and belt was put on at end of last season cause i burnt old one. clutch faces are clean and smooth and all parts in primary looked good when i put new spring in. this sled used to pull 90-110kph consistantly with the clutches set for the dacomax belt i run on it. any thoughts or hints? anyone know the base weight for the primary weights? 
