Checking belt align and deflection how to?


captnviper said:
This is what mrviper700 recomended for my friends 98 8dn-20 out of a 2000-02 srx, use 4.5 rivets in both holes, use a w/w/w/ primary spring, stock 15.6mm rollers. get a 50-44, or 51-45 helix with a green dot sec. spring at 60-70 twist for the rear clutch, will really wake it up. The 8dn-10 are very close to the -20.
Click to expand...

Thanks for that suggestion! How's your buddy's sled on the lake? How about the trail? Top speed? What's his fastest mph? Thanks again
 
It's got an m-10 and 1 1/4" ripsaw so top speed is not what you would get in stock form on the suspension, but it back shifts nice and pulls pretty hard. But most of all his clutches are way cool to the touch. The setup that was in it when he bought it used was blowing belts because of heat.
 
captnviper said:
It's got an m-10 and 1 1/4" ripsaw so top speed is not what you would get in stock form on the suspension, but it back shifts nice and pulls pretty hard. But most of all his clutches are way cool to the touch. The setup that was in it when he bought it used was blowing belts because of heat.
Click to expand...

Very good to know. Thanks again for the heads up!
What exact helix is he using do you know? And by not as fast as a stock skid are we talking like he doesn't get over 100mph?
 
You must log in or register to reply here.


Back
Top