Track to tight 98 vmax 600 xtc.

[Tjc702]

I bought a Challenger track 679-9793 with a 1 inch lug. It said it was a 151x15 252 pitch. I have a 4 cogs on the driveshaft. I installed it and it doesn't seam to fit right on the cogs and it is way to tight. I didn't compare it to the old track. What is wrong?

 

[EotS1]

Did you mean 121x15?

A new track can fit ugly when you first put it on due to the folds in it from being bundled up. It's going to need to be run a bit and adjusted after that...

 

[Maim]

if you can pull the track around the drivers by hand, it will work fine. had one where i beleived the parts guy on driver pitch and discovered i was wrong when i went to rotate the track. man that one sucked.

 

[Tjc702]

I got it to fit. I had to grind the outside lugs on one side about 1/4 inch to get it to fit.

 

[74Nitro]

Sometimes the outer drivers move on the shaft either inward or outward.

 

[MrSled]

I got it to fit. I had to grind the outside lugs on one side about 1/4 inch to get it to fit.

You could have just pressed that driver in too.