ok got all my clutch parts in now for my sxr 500.
the question is where is a good starting point? (after i do centre to centre and offset)
the weights are thundershift 40 gram base with 3 holes usin 15mm rollers with 2 engagement shims as per vmj 500 setup with a 47/41 dalton for secondary.
should i divide the weight evenly between all 3 holes + the little bit im short for the weight difference in the 8ab's he uses in his setup?
8ab=41.0g and he uses 2.4 in both holes.
thanks cameron
ps yamahaman after in done with the centre to centre tool and offset yes you can borrow them.
the question is where is a good starting point? (after i do centre to centre and offset)
the weights are thundershift 40 gram base with 3 holes usin 15mm rollers with 2 engagement shims as per vmj 500 setup with a 47/41 dalton for secondary.
should i divide the weight evenly between all 3 holes + the little bit im short for the weight difference in the 8ab's he uses in his setup?
8ab=41.0g and he uses 2.4 in both holes.
thanks cameron
ps yamahaman after in done with the centre to centre tool and offset yes you can borrow them.
