helix question

[SX700R RIDER]

I have a 2000 SX 700R with a Bender CLutch Kit. The helix is a Bender 9760 trying to go to a 51-43 which I was told was a stock 2003-2005 RX1 helix. I ordered one today, but question the part number. Does anyone know the Yamaha part number for this helix? The part number I ordered was 8BV-17604-51-00 and would a 51-43 be an improvement over the 9760 which is a 49-45. Thank you!

 

[change_up]

Well if all your info is right... that part # is for a straight 45 helix. The 51-43 is 8FA-17604-00-00.

 

[SX700R RIDER]

the yamaha shop I went to pulled up 03 rx1 on the computer and listed 2 numbers 8BV-17604-51-00 $100.88 and 8fa-17604-00-00 $94.04. Why the price difference? The reason I ordered the first part number was because I thought it had bushings installed. Thanks Change Up. How sure are you on that part number? DId you get it out of a book, web site, etc???? Thanks

 

[Turk]

I have that helix(51/43 RX-1) for $50 shipped to your door. They come with bushings.

 

[SX700R RIDER]

thanks turk I could stop the order and how do I contack you.

 

[Turk]

PM e at
brodam@westman.wave.ca
I also take paypal at that same address. I can ship it out today but might take 2 weeks to get to you from Canada.

 

[change_up]

I am sure about those #'s. You'd be surprised how good this site is for you. Here's the link to the totallyamaha tech page with the helix angles. http://www.totallyamaha.com/snowmobiles/aaTECH/drivespecs/camangles.htm

 

[SX700R RIDER]

thanks change up been to that page before. Always looked AT the angles and the force arrows. did not realize the part number was there.thanks again