snowfoxsx
New member
ok, i have a 97 700sx with a 2000 600 lower end and a set of 700 ported cylinders, make unknown (unless someone knows who marks the cylinders with this mark: M1057, M1058, M1059, HELP ANYONE?) anyways i would like to know what rpm's it should run at, it has bender triples, reed spacers, carbon fiber "ht" reeds and jetting per bender specs with porting (152.5x3 with 55x3 pilot's, air screw 1.5 and needle's at clip 4) and 89l weights with 2.4 gram, ygy primary and green secondary at 70 degrees i think. 1.25 doo snocross track, stock gears and the motor is fresh. i weigh about 210.
when i nail it it slightly bogs then cranks up to 8200 then climbs up to around 85-8600, does it seem right? it seemed to run better with the 150 mains and 52.5 pilot's, clip at #3, more responsive and better pickup with no bog, or is this because of the warm temps here right now and the 152.5's will be better when it cools of a bit? run lots of ditches and lakes and fairly straight trails here in eastern mb so any setups you recommend?
any help would be great! thanks guys.
when i nail it it slightly bogs then cranks up to 8200 then climbs up to around 85-8600, does it seem right? it seemed to run better with the 150 mains and 52.5 pilot's, clip at #3, more responsive and better pickup with no bog, or is this because of the warm temps here right now and the 152.5's will be better when it cools of a bit? run lots of ditches and lakes and fairly straight trails here in eastern mb so any setups you recommend?
any help would be great! thanks guys.
