What is wear limit of secondary ramp shoes pics attached

sandmanmike1

sandmanmike1

New member
Joined
Nov 11, 2004
Messages
847
Age
52
Location
Wyandotte MI
Here is the secondary I just got for my 94 Vmax 600 ST how do the ramp shoes look? Should I replace them?
 

Attachments

  • shrank100_1082.JPG
    shrank100_1082.JPG
    48.1 KB · Views: 4
  • shrank100_1083.JPG
    shrank100_1083.JPG
    53.6 KB · Views: 3
  • shrank100_1084.JPG
    shrank100_1084.JPG
    48.2 KB · Views: 5
Last edited:
Wear limit on a '94 Ramp shoe is 1.0mm(.04 in)

Your only allowed that much wear on a new shoe
 
Last edited:
I am unsure of the mileage. It is a little dirty ang I will clean. How hard is it take apart and reassemble by yourself
 
You can buy aftermarket for about a buck a piece. My dealer sells the genuine yamaha for about $10 ea. A lot cheaper then new metal clutch parts...

Easy to take it a part, just take your time and pay attention to what holes the spring lines up in.
 
Those will work for this year prob, but if you are not using that clutch yet and don't need it to get out riding soon i would replace them only a few bucks i got genuine for like 7 each or something like that, also check the bushings and ramps ect for wear.
 
Mike, I just did mine on the black 95 V-max up in Irons. You can pick them up at Rec& Leisure in Farmington or order them from Shadetree ( About $2.00 each). I could'nt believe how easy it was! There will not be any tension at all on the spring when you get the three nuts far enough out. Just make sure to put marks on everything before you take it apart. Mine were about as worn as yours. Two of those sliders were completely gone on one of the red V-max's, replaceing them made a huge difference. I just got back about an hour ago, the side streets and two tracks are pretty good up there but the trails sucked!
 
You must log in or register to reply here.


Back
Top