making a center to center alinment tool?

terret725

New member
Joined
Sep 29, 2005
Messages
972
Location
berkshire mass
any one have the center to center mesaurment for one of the clutch tools that slips over the shaftss u can tighten the motor in teh right place. ive been a horible time getting my cluthc to sto squeeling sence i put the new belt on. its rubbing on the primary shaft and the cogs of the belt. i wanna cut out one of these tools so i can get it right.m id by one but i dont have a 120 bucks.
 
terret725 said:
any one have the center to center mesaurment for one of the clutch tools that slips over the shaftss u can tighten the motor in teh right place. ive been a horible time getting my cluthc to sto squeeling sence i put the new belt on. its rubbing on the primary shaft and the cogs of the belt. i wanna cut out one of these tools so i can get it right.m id by one but i dont have a 120 bucks.[
You problem is not center to center it is offset! Mine squeeked like rat! loosened up the mounts got the motor moved within spec no mo squeek!
 
Don't forget to also have the proper number of shims on the backside of the secondary. If your belt is too high it will squeel like hell and may even start moving on its own on flat hardpack.

The belt should be sitting just at the top of the secondary to slightly above. about the thickness of a penny. I can't seem to locate the exact spec in the service manual.
 
Last edited:
is that for both or just one? cause i ahve the offset too i just want the center to center. or does any one have a used one they would like to sell.
 
center to center mesurement-268.5mm
offset-15mm
secondary freeplay(slack when pulin and pushing on secondary) between 1-2 mm
belt deflection-.5mm under top of sheave to 1mm over top of sheave
Pat
 


Back
Top