Phazer II mods

S

Skidor

New member
Joined
Feb 18, 2005
Messages
22
Location
Lakeport, CA
I just bought my first 2 phazer II's, a 97 Mtn light and a 93 480 ST.
What do you all know about modding these things? I've got 1 inch tracks on both. The 93 has a Aean pipe, and feels as though the clutch has a much better setup with a lot of power through midrange. It doesn't seem to want to idle though when I get above 7000 feet elevation.

I need to raise the handlebars, and maybe widen them if possible. Any aftermarket risers fit? How about wider handle bars?

I wouldn't mind seeing if a Venture hood will fit on it and deleting the windshield/headlight pod.
 
I raised my bars 3 in. but I don't recommend going higher than 2 in. unless you get a longer brake cable! It's a little taunt with 3 inches and will apply the brake with the bars turned all the way to the left.
 
phazer95 said:
I raised my bars 3 in. but I don't recommend going higher than 2 in. unless you get a longer brake cable! It's a little taunt with 3 inches and will apply the brake with the bars turned all the way to the left.
Click to expand...


Did you get an aftermarket riser block or just cut and weld a length of tube onto the downshaft?
 
I used a powermadd riser block on top of the fairing mount then took another fairing mount and cut of the ears off and mounted the handlebars from there.
 
Do a search as this topic was raised not too long ago:

Aaen pipe, clutch and port work-1.25 ripsaw with drop brackets for the rear skid. If the 93 is not long-tracked already-go ahead with that mod. Also, widening kits are available.
 
..SNAKEBIT.. said:
I know the 1993 Exciter SX had wider bars but dont know if they would fit?[/QUOTE

Do you have one? Could you measure the bars end to end?
I know that the Phazer II bars were about an inch wider than the Phazer I.
Click to expand...
 
You must log in or register to reply here.


Back
Top