VenomMod
New member
Is porting worth the money? I'm running a 600 with triple pipes. I was looking for a little bit more power and scoot at top end. If i port it, who would be the best to look into it?
Porting
- Thread starter VenomMod
- Start date
xsivhp
Active member
Why not put a viper motor in there - save you a lot of headaches, and you could still triple pipe it. Just curious.
VenomMod
New member
My ultimate goal is to build 835 and drop it in. But, i'm not ready to venture down that road. I just want to make my 600 quick.
gild
New member
cost
Porting my 700 cost about $900 Canadian and there was a notiable difference. Putting a non power valved 700 motor or top end may be just as cheap if you buy used on this site. I have had no problems with porting, single headgasket and SLP triples at 8900 on a 700. put on over 8,000 ks with the porting and total of over 12000 ks all together and still running.Someone on this site had ported 700 cyls for sale so maybe check that route out.
Porting my 700 cost about $900 Canadian and there was a notiable difference. Putting a non power valved 700 motor or top end may be just as cheap if you buy used on this site. I have had no problems with porting, single headgasket and SLP triples at 8900 on a 700. put on over 8,000 ks with the porting and total of over 12000 ks all together and still running.Someone on this site had ported 700 cyls for sale so maybe check that route out.
reddog mmax 700
New member
75
yeah real expsive it cost me 75 bucks to get the templates off this site
yeah real expsive it cost me 75 bucks to get the templates off this site
gild
New member
price
yup its nice when you got the equipment, time, knowledge and templates plus the I can do it myself confidence.
yup its nice when you got the equipment, time, knowledge and templates plus the I can do it myself confidence.
reddog mmax 700
New member
yep
any body can have the(i can do it my self)...just stand up and take it
any body can have the(i can do it my self)...just stand up and take it
gild
New member
yup
I just didn't have the time but had the money.
I just didn't have the time but had the money.
ExpertXViper
New member
VenomMod: Have you talked to MRVIPER700 about porting for your sled???? If ya havent I would suggest PM him with any question you may have.
VenomMod
New member
I will, thank you.
yamaholic22
Active member
buy those ported 700 cylinders from betheviper and get a set of 700cc pistons and rings and a bit fatter jets and make that thing a sleeper "600".