x2ryder
New member
I have a 2002 SRX ported with v force 2 reeds and a Peak performance head. Was looking at these 38 TMX carbs. Anyone run these do they give any performance benefits or just drink more fuel?
Thanks
Thanks
38 TMX carbs
- Thread starter x2ryder
- Start date
valin
Active member
Yes, run them. Get a set from a Mach Z. They are the same width and spacing as the SRX carbs. They work well.
x2ryder
New member
Any idea where I could find a set? Where do you notice the difference?
valin
Active member
If you run them, you must take the dividers (if you have them), and the shelf out of the airbox. Also drill holes or cut a slot into the top cover under the foam to get more air in there.
x2ryder
New member
Would these be Tm or TMX flatslides? Also what is the difference between TM and TMX?
http://cgi.ebay.com/ebaymotors/ws/e...STRK:MEWA:IT&viewitem=&item=170155340578&rd=1
http://cgi.ebay.com/ebaymotors/ws/e...STRK:MEWA:IT&viewitem=&item=170155340578&rd=1
valin
Active member
I am not sure if they are TM or TMX. Get a set of carbs off of a '98-03 Mach Z. Go to the dootalk.com forums. You'll find a few sets there.
x2ryder
New member
What do you do with the tps?
valin
Active member
I am trying to recall how the stock carbs plug in. I haven't run them in quite some time. I believe you simply take the wires and plug them into each other instead of the tps. One of the lights on your dash will be on steady, but it doesn't affect performance.
i have the set that valin sold me, never used them, at least i think that is who i bought them from, bought them a year or so ago and never did use them. anyway, 200 shipped
let me know
scott
let me know
scott
crazykid
New member
Hey guys, I just picked up a set of 38's, the mains are 430, pilot 50, thats as far as i got on checking them out. Now i have question,with the float bowl removed i noticed that one of the little brass tubes that stick out from the bottom is shorter than the other two,Is this normal? I sure hope it is.Oh yeah also does anyone know what the clip position should be for the needle,i want to make sure and check,dont want totake for granted that its in the proper position being they are from a tottaly different sled. Please let me know boys. Thanks
YAMMIEGOD3:16
Active member
NOT %100 SHURE HERE BUT I THINK TMX IS MIKUNI MODEL NUMBER THAT DEFINES SNOWMOBILE CARB. TM I THINK IS DIRT BIKE. 3:16 (yammie tony)
mopar1rules
Active member
i thought the TM series had no power jet and the TMX series had the power jet???
linemech31
New member
would these carbs help a stock srx?? with only clutching mods
mopar1rules
Active member
IMO, no, but great for a 835bb srx.
Triple X
New member
mopar1rules said:
I agree with mopar1rules, on a stock engine it would be a waste of money. Put 38's on a BB or a ported & piped SRX and see a 8hp gain according to the dyno.