BLUE DEVIL 700
New member
does anyone have the instructons for installing Bender Transfer rods,i got a set of used ones but no instructions.just want to make sure everything is included as well.
Thanks
HAPPY NEW YEAR EVERYONE!!!!
Thanks
HAPPY NEW YEAR EVERYONE!!!!

Last edited:
SnoGasm
New member
Give Bender Racing (716-941-5840)a call they should be able to help you if not I could email you the instructions if I still have them.
BLUE DEVIL 700
New member
if you could Email them to me it would be great,let me know if you can find them.SnoGasm said:Give Bender Racing (716-941-5840)a call they should be able to help you if not I could email you the instructions if I still have them.
SnoGasm
New member
They are easy to put on, I will try to find the instructions and email them to you.
patsxr700
New member
yeah they r easy i did about 5 sled withs rods only hard part is putting the skid back in :P u knoly have to take off 2 bolts that hold the rear part of the skid then u can heat the bearing by a heat gun... thenn just get a 2x4 and hammer on one side of the shaft then it should pop off u dont have to worry about the other side pull the shaft right out might be alot of greese but whach the 2 washers on each side and the bushings :P once you pull that shaft out both rods will fall and u have to take the bolt off the bottom of the rods and the whole rod will come out... once u have it out u have to take the bolt off the bottom of the rod and put it on the bender rods... torch that bolt seems like yamaha like locktight in that area lol then just go backward from there haha
Concept Carbon
New member
I beleive they just install onto your old rods. just remove the 2 bolts on both sides and install, you may have to remove on back wheel and slide the other over, and loosen the track. its very easy.
BLUE DEVIL 700
New member
i just want to make sure i do it correctly,i have to swap my track so i'll probley do it while i have the skid out.Snogasm i'll pm you with my E-mail Addy.
Thanks guys!
Thanks guys!
bump
Anyone have a set of instructions they could email me? In the same boat as the OP, bought a used set. I know how to install them, but was curious what washers where and what height of the adjusting nut to start with. Thanks.
Anyone have a set of instructions they could email me? In the same boat as the OP, bought a used set. I know how to install them, but was curious what washers where and what height of the adjusting nut to start with. Thanks.