Eating rollers in primary clutch

[1fastmax]

hi everybody i have a 94 vmax 600 that loves to eat up rollers they last 1 day. theres nothing broken in the clutch, i have 8ca weights and a O-
P-O spring, what slould i do or whats the problem can someone help me. thank you.

 

[snowdad4]

those early clutches liked to eat themselves. harmonics and design. replace with a newer one, (97 on up), should have better luck.

 

[fishx65]

Better read this: http://www.totallyamaha.net/forums/showthread.php?t=57211

 

[1fastmax]

well the clutch thats on there now is from a newer year not sure which year.

 

[quad]

Typical

Those '94's need the updated flywheel, not all but some did have bad harmonics right in the rpm range that you operate. I had a 94 went through all of that and it went away when changed the flywheel

 

[tedgoesfast]

the cover bushing if it is loose it will beat out rollors

 

[1fastmax]

which year flywheel? thanks

Those '94's need the updated flywheel, not all but some did have bad harmonics right in the rpm range that you operate. I had a 94 went through all of that and it went away when changed the flywheel

 

[quad]

flywheel

In 95 they went to the heavier flywheel. I know that worn shaft bushings could be the culprit but they will wear out faster than they should you know one thing leads to another.

 

[mdbauer62]

I had a 95 VMAX 600 that ate rollers after about 4,000 miles. Then, new rollers every season at least. Finally swapped out to a newer clutch from a 2001 SXR 600 and no more problems. My advice: Get a newer design clutch.