rx1jim
New member
There is a hose which comes off the SRX oil pump that is held by a bracket under the center carb. It is plugged with what looks like a bolt. What is the purpose of this piece of tubing and the bolt plug??
SRX oil pump
- Thread starter rx1jim
- Start date
rx1jim said:
Thats the oil pump bleeder line.
kirk700 srx
Member
It is a bleed for the oil pump to remove any air in the line
snowcrazy
New member
if you take the engine out then you bleed the pump otherwize you should not have to
daman
New member
rx1jim
New member
Yes, Daman, that's it. From what everyone is saying it sounds a bleeder port for the oil pump. I'll need to use it since I am rebuilding the engine. Can someone please explain the oil pump bleeding process? Is it done while pull starting the engine or while the engine is running. I am going to start the fresh engine with a tank of premix gas. I'll watch the oil tanl level to be sure the pump is working by running the engine on premix. Thanks!!
daman
New member
Right that's the bleed hose ,crack that open wile running and let air out,running premix is good idea it's getting oil wile pump is priming up,do that and after a few mins pump will be good and primed up by the time that pre mix is used up.
rx1jim
New member
Thank you very much!! The terrific members on this site do an excellent job of sharing info.!!
daman
New member
Anytime,good luck Jim...