Powervalve Adjustment

[Gagt518]

I tried to adjust the powervalves but must not be doing it correctly? I started her up and idled her down below to 900Rpm. I did all the steps that were listed in the link at the bottom of this post. Im using allen wrenchs for spacers. I loosened the adjusters at the servo and when i go to tighten them up the PV housings dont come together like it states in the post. Dont know what im doing wrong?

http://www.totallyamaha.net/forums/showthread.php?t=55400

 

[Ride.Race.Live]

a way thats easier to adjust the valves is to take off the exhausts and fell up there with ur hand and just adjust them until flush.... thats what i did... it takes longer but find its alot easier then to do the 2.5mm alen key trick...

Not sure why ur housing isnt coming back together when u tight them though...

 

[kirk700 srx]

I tried to adjust the powervalves but must not be doing it correctly? I started her up and idled her down below to 900Rpm. I did all the steps that were listed in the link at the bottom of this post. Im using allen wrenchs for spacers. I loosened the adjusters at the servo and when i go to tighten them up the PV housings dont come together like it states in the post. Dont know what im doing wrong?

http://www.totallyamaha.net/forums/showthread.php?t=55400

I figure you have a couple pull throughs Thats what happened to me! I couldn't get adjustment s set right hauled all apart and I had 2 pulled thru valves!

 

[daman]

so when you start to tighten the adjuster bolts what happens?? what moves the servo pully or nothing?

no pulls throughs you checked for?

and the RIGHT way is Yamahas way(2-3mm) not feeling for in the exhust port,thats too tight adjustment.

 

[Gagt518]

When i pulled the valves out to clean them i disconnected them from the cables. So i would of known if there was a pull through or not. Ill pull the valves again tomorrow and see if the cables is still attached.