sbsho
New member
I currently have a 95vmax 600le with 3in drop brackets on the rear. i am picking up a camoplast 136x15x1.25 that has 144 or 196 studs in it, cant remember, for real cheap. i also just purchased 8t drivers and im ordering rail extensions next week to extend the 121 skid to 136.
Now will i be able to install my 8t drivers, extend the skid and put on the track with no issues? Now does this sled have tunnel protectors on it? And will i need them even though im putting in 8t drivers? If i do need the protectors which ones should i buy and how many. If someone has the same or similar setup with pictures it would be great to see. thanks
Now will i be able to install my 8t drivers, extend the skid and put on the track with no issues? Now does this sled have tunnel protectors on it? And will i need them even though im putting in 8t drivers? If i do need the protectors which ones should i buy and how many. If someone has the same or similar setup with pictures it would be great to see. thanks
sbsho
New member
does anyone know if im fine or not?
sounds like you'll be alright , you will most likely have to regear it if im not mistaken after the driver change. check here , got some good info in an old thread i had started
http://www.totallyamaha.net/forums/showthread.php?t=64163
http://www.totallyamaha.net/forums/showthread.php?t=64163
knocksum
New member
My 95 600le didn't come with a front cooler or protectors. Can someone confirm that the electric start models came with no front cooler?
My 8t drivers work great. Your stock should be 21/37 1.76 ratio. After 8t drivers you should be around 1.99 ratio. Which is still not bad. I felt this machine was grossly over geared anyways.
My 8t drivers work great. Your stock should be 21/37 1.76 ratio. After 8t drivers you should be around 1.99 ratio. Which is still not bad. I felt this machine was grossly over geared anyways.