Bleed screw in rear heat exchanger on 03 Viper?

D

drfbuster

New member
Joined
Oct 27, 2003
Messages
26
Took my carbs of the other night and let the sled sit all night with no carbs anyway i had the carb heater knob off but i lost all my coolant from the tank some how. i assume i will have to bleed the cooling system. anyway is there a bleed bolt under the rear of the seat and tunnel? do i need to access this bolt if there is one to properly bleed the system or can i just bleed the system from the front of the sled?
 
My question is how do i access the rear bleed bolt if its under the tunnel? will i have to locate the bolt and drill a hole in the tunnel i do have the rear heat exchanger?
 
drfbuster said:
My question is how do i access the rear bleed bolt if its under the tunnel? will i have to locate the bolt and drill a hole in the tunnel i do have the rear heat exchanger?
Click to expand...
is it under the tunnel? you didnt post that in your opening question. gota dig and measure to find it.
 
tried to bleed the rear heat exchanger and after 15 minutes of idling the coolant still had air bubbles coming out so i hit the throttle a few times and still same thing no even flow of coolant just air bubbles so i gave up and lifted the front of the sled and took out the bleeder bolt and i couldnt get any coolant to come out the hole... I assume im supposed to lift the front of the sled to bleed the front bleeder. Also i didnt have the coolant cap off because all of the coolant started coming out. any suggestions would be greatly appreciated. thanks! drf
 
You must log in or register to reply here.


Back
Top