drfbuster
New member
- Joined
- Oct 27, 2003
- Messages
- 26
Took my carbs of the other night and let the sled sit all night with no carbs anyway i had the carb heater knob off but i lost all my coolant from the tank some how. i assume i will have to bleed the cooling system. anyway is there a bleed bolt under the rear of the seat and tunnel? do i need to access this bolt if there is one to properly bleed the system or can i just bleed the system from the front of the sled?
Concept Carbon
New member
you need to access this screw its under the seat do a search there is lots on this topic.
daman
New member
search,lots on this...
im not sure if id worry about it(unless it was a big puddle),anyway here....
http://www.totallyamaha.net/forums/showpost.php?p=229250&postcount=13
im not sure if id worry about it(unless it was a big puddle),anyway here....
http://www.totallyamaha.net/forums/showpost.php?p=229250&postcount=13
drfbuster
New member
- Joined
- Oct 27, 2003
- Messages
- 26
My question is how do i access the rear bleed bolt if its under the tunnel? will i have to locate the bolt and drill a hole in the tunnel i do have the rear heat exchanger?

staggs65
Moderator
here you go, just dont make the same mistake he did
http://www.totallyamaha.net/forums/showthread.php?t=66016
http://www.totallyamaha.net/forums/showthread.php?t=66016
daman
New member
is it under the tunnel? you didnt post that in your opening question. gota dig and measure to find it.drfbuster said:My question is how do i access the rear bleed bolt if its under the tunnel? will i have to locate the bolt and drill a hole in the tunnel i do have the rear heat exchanger?
drfbuster
New member
- Joined
- Oct 27, 2003
- Messages
- 26
tried to bleed the rear heat exchanger and after 15 minutes of idling the coolant still had air bubbles coming out so i hit the throttle a few times and still same thing no even flow of coolant just air bubbles so i gave up and lifted the front of the sled and took out the bleeder bolt and i couldnt get any coolant to come out the hole... I assume im supposed to lift the front of the sled to bleed the front bleeder. Also i didnt have the coolant cap off because all of the coolant started coming out. any suggestions would be greatly appreciated. thanks! drf