SXR Pro Action Install help!

[BLUEBALLER]

Try loosening the bolt for the FRA, and setting it in the medium or hard position. It just might be enough for the rear bolts to line up.

 

[maxdlx]

Also turn your ts3 so they are flush on top, or at full transfer, It will give you more room. Maxdlx

 

[BLUEBALLER]

after looking at your first picture again, I would say that your FRA bracket is in backwards. I believe the teeth go to the front of the sled. Looks like yours are in backwards.

 

[pbspecial]

After all that, yes, it was in backwards! Once I flipped it around, it lined right up no problem. Oh well, at leas I know what I'm doing now. Thanks for all the help.
PB

 

[MrSled]

Good catch BlueBaller , I new it had to go in easier than that...

 

[YaMon]

Would you suggest locktite? Red or Blue?

 

[Maim]

blue only. red too hard to break loose later.

 

[2ooosrx]

agreed, red is very hard to break when you take it off again. Inless you have air tools, I would not suggest it, go with the blue, it will be more then enough

 

[MrSled]

And I will make the blue as well...its unanimous

 

[familyman]

I have never loosen my rods, just used a rachet strap to compress the spring and align my bolts. Rear lifted and use a floor jack....Might have to try the easy way next time. Brent

 

[pogoyammie]

yeah familyman...do it the easy way...lines right up (as long as nothing's in backwards...and yes pbspecial, we all have put plenty of stuff in backwards, admit it or not)