Will I be ok disconecting oil injection and running pre mix on 02 700 viper. My main concern is the injection line to base of block!
disconecting oil injection 700 viper
- Thread starter glinfam
- Start date
I'm no professional wrench, but I've read on here that most TY'ers recommend to NOT disconnect the oil line -- that it's very reliable and more effective than premix.....
I know TY'ers have been very consistent about this. You may even want to try a search!
Mike
I know TY'ers have been very consistent about this. You may even want to try a search!
Mike
Problem is I am Turbo charging and my fuel management wont allow the lower press oil injection.
Ya know, I just realized I bet you are asking about your 4 stroke RX 1!!!!!!
What I was referencing was Viper and SRX threads I've read, so I'm very sorry.
There is actually a 4 stroke forum (this is the 2 stroke forum!) -- Just click the link at the top left of the page.
Then I'd register there and post this under the RX section, or better yet, the Turbo/ Supercharger section.
Good luck!!!!
Mike
What I was referencing was Viper and SRX threads I've read, so I'm very sorry.
There is actually a 4 stroke forum (this is the 2 stroke forum!) -- Just click the link at the top left of the page.
Then I'd register there and post this under the RX section, or better yet, the Turbo/ Supercharger section.
Good luck!!!!
Mike
No I am refering to my 76 srx that I have been running a 700 viper motor in for the last 2 years and I am getting close to raping up the Turbo on it.
SX600abuser
Member
I'm pretty sure you don't want to disconnect that as it feeds the bearing directly. In fact I am not sure if premix could even get to the bearings effectively enough. I am just playing off memory though, I am sure other guys will know better for sure.
Thats my concern, I am not sure if intake charge is isolated from that brearing.