GibViper
New member
I have spent the last three days searching this post and breaking down my carbs on the Viper. Hoping I can get some guidance and figure this thing out before a trip up north Thursday...
Carbs have been cleaned three times in the last two months and sled was running great up until last week after a WOT lake run. Ran fine for another 10 miles or so then I noticed this...
Starts great, idles nice and runs from mid to WOT like always, however, once you coast to an idle and give it the gas, she bogs and sound like a cylinder isn't firing. Come to a complete stop and accelerate again, all is fine. Have no clue... PVS were cleaned last fall. I am going to pull those tomorrow but wasn't sure if a pull through would cause this???
Also, checked the plug caps..all within spec. Pulled the plugs and the PTO side looked pretty dark but not oily.
Any advise would be greatly appreciated
Carbs have been cleaned three times in the last two months and sled was running great up until last week after a WOT lake run. Ran fine for another 10 miles or so then I noticed this...
Starts great, idles nice and runs from mid to WOT like always, however, once you coast to an idle and give it the gas, she bogs and sound like a cylinder isn't firing. Come to a complete stop and accelerate again, all is fine. Have no clue... PVS were cleaned last fall. I am going to pull those tomorrow but wasn't sure if a pull through would cause this???
Also, checked the plug caps..all within spec. Pulled the plugs and the PTO side looked pretty dark but not oily.
Any advise would be greatly appreciated
