venture belt squeel and pulling ahead

check to see if the shoulders on the bolts in the back of the secondary are worn off. if not remove a shim to open the secondary a little more
 
700scott is right, Also check the plate on the opposite sheeve of the bolts for wear. You can flip it if it is. Soc
 
sockey... thats what it was, the plate had spots in it from the bolts. i flipped it and all is good. glad to hear that it was ok to flip, because i did it on a wing and a prayer. it worked :rockon:
 
Hey Guys. I put a new belt on my 700SX and it creeps ahead now. The belt is sitting slightly below the top of the secondary, and I've removed all the washers from the three bolts. Is there anything else I can do to adjust this more?

What do you mean when you say take the plate off and flip it over? And what do you mean by the "shoulder of the bolts" worn off?
 
There is a brass colored plate on your secondary. It is where the 3 deflection bolts hit. If the plate has and detents where the bolts are hitting it then you should flip it to have a flat surface again.

Check the 3 deflection bolts When talking about the shoulder worn off it just means that the end of the bolts are worn down.

Hope this helps.
 
It helped a LOT. Both those problems were evident on my secondary. Thanks for your help, and Merry Christmas everyone!
 
You must log in or register to reply here.


Back
Top