chris700readhead
Member
Here's the moded sex Reed blocks. Also I ported the sx carb boots so there is a smooth transition between the boots and stuffers.
chris700readhead
Member
Got the new skid in today. Only drilled two holes in the wrong spot but all in all it was an easy swap.
yami1
Member
looks good. I would put a few more rivets in those relocated plates.
chris700readhead
Member
I did I had to go get more rivets after I took the first picture.
yamyrider
Active member
chris700readhead said:Here's the moded sex Reed blocks. Also I ported the sx carb boots so there is a smooth transition between the boots and stuffers.
How do I get "sex" reed blocks
chris700readhead
Member
Srx. Damn auto correct. Lol
chris700readhead
Member
J_hubbs
New member
When two reed blocks find each other attractive.....yamyrider said:
That is the best auto correct iv'e seen in a while! HA!
A couple of bucks
VIP Member
It when a twin cylinders reed block propagates. Thus, a triple is born.J_hubbs said:
Last edited:
sleddineinar
VIP Member
Looking good!
chris700readhead
Member
Thanks Sleddineinar. Supposed to have my case back from don today so I can start putting the bottom end back together. Can't wait to see how this new setup performs.
chris700readhead
Member
Got the bottom end put back together his morning. One step closer.
you remebered to use a nice thin layer of yamabond on the case seam right? cant see it in the pic.
chris700readhead
Member
Yes. And a little anerobic on the edges of the crank seals. For a little piece of mind. Thanks don. The case looks awesome.
chris700readhead
Member
Well got the top end back from don today. And it looks awesome. Well got busy and started outing it together. Also got the fuel tank cleaned out new filter and pickup tube. And installed xtc radius rods and venom tie rods to finish the long travel front. The motor will be going in tomorrow and heading north Sunday to find snow and tune this thing. I'm going to be in munising for a week trip starting the 23rd so its gotta be ready for a week of riding.
sleddineinar
VIP Member
That toe-in looks a bit severe...
chris700readhead
Member
Ya it helps keep the darting to a minimum lol. That pic was before I had the tie rods in.
chris700readhead
Member
Motors done just have to check spuish now.
yami1
Member
Looks good. Just bustin your stones a bit here. Have those nice shiny jugs and you put those rusty nuts back on jug and head. What the hell dude??? I understand you been working on this forever and sure you just want to ride. Get us some pis when done
chris700readhead
Member
Well it runs went through its first heat cycle about an hour ago. Everything went realty well. The squish was .067 and good to go. I do another heat cycle in a bit and then rip it down the yard to check the jetting.
