bolt size to pull clutch w water method?

[tnc110]

If I understand this method correctly, you remove the clutch bolt, put the sled on its side, fill the hole with water and tighten a teflon tape wrapped bolt until it pops off. Question is what size bolt must be used? Also, what size bolt for a polaris primary. I have to pull a yamaha and polaris clutch.

Thanks!

 

[SHARK]

If I understand this method correctly, you remove the clutch bolt, put the sled on its side, fill the hole with water and tighten a teflon tape wrapped bolt until it pops off. Question is what size bolt must be used? Also, what size bolt for a polaris primary. I have to pull a yamaha and polaris clutch.

Thanks!

Use the clutchbolt.

 

[chris700readhead]

The clutch bolt won't work it screws into the crank and won't create the hydraulic effect I use my clutch puller along with water, works like a champ.

 

[tnc110]

restOTE=SHARK;651458]Use the clutchbolt.[/QUOTE]

that works on doos, but not the rest

 

[tnc110]

The clutch bolt won't work it screws into the crank and won't create the hydraulic effect I use my clutch puller along with water, works like a champ.

do you know the thread size and pitch of the pullr

 

[fourbarrel]

18mm x 1.5 pitch

 

[fastsrx]

Yamaha puller 18x1.50
polaris 3/4x16

 

[tnc110]

thanks fellas!