2004 Viper S
- Thread starter MURDER YAMAHA
- Start date
How'd the main nozzles look? I'm not sure if they're even available anymore.
Honestly, i just made sure they were clean, never gave the wear any thought.
Maybe I should take a closer peek.
Maybe I should take a closer peek.
What's the miles on it?
Good job cleaning it up!
I can’t recall, i think around 6500.
I may have another set of viper carbs somewhere.
But would be unknown miles on them also.
I may have another set of viper carbs somewhere.
But would be unknown miles on them also.
You mean main jets? They should be avaiable
No the nozzles. The holes at the top wear bigger as age and miles pile up causing rich mid-range and poor mileage.
He is talking about the brass piece that the needles ride in.
looking good!!
Awesome looking sled!
Right on. I've welded so many of those arms over the years. Terrible design there.
Looking good though, nice work.
Suspension completely gone through.
New bushings, recharged shocks, reset lengths of limiter straps, springs ect.
New hyfax and all wheels.
Took parts from 2 different skids, but got it done. Lol
Also had the track and drive axel out.
All new bearings and seals in chain case and speedo bearing. Checked drive wheel spacing, all was good.
New bushings, recharged shocks, reset lengths of limiter straps, springs ect.
New hyfax and all wheels.
Took parts from 2 different skids, but got it done. Lol
Also had the track and drive axel out.
All new bearings and seals in chain case and speedo bearing. Checked drive wheel spacing, all was good.
Attachments
