SC10 2 into SRX

Do a mockup wham with the weight on the skid even with a bud on it checking if you like were it will sit.Should be easy with the brackets you have for the rear.The front maybie a block of wood to hold the axle away from the top of the tunnel.

If it sits to high remove the top axle and after checking the depth of the holes cut the axle to size and drill and tap the threads so you can rebolt.Or will another axle work?
 
just waiting on seals for chaincase then i will post pics of my new sc 10 III install.
 
Hey Blue,
Can you provide a little more detail on where to drill my new holes on my SRX, to input the SC10-III? Where do you first measure from and which holes do you need to drill out?

Thanks,

John
 
I will try john if you look at the 2nd last pic on page 1 you will see the rear washer in the original location and another behind it with the large allen key bolt that the doo skid uses.Meashure from that mount to the front of the sled 23 1/2 inch.
 
Viper Treats said:
I think you need drop brackets. I tried a SC10III in a viper without drop brackets and you couldn't get any ski pressure. Drop the suspension and make a template from your buddies skid, make sure the year models match skid and sled unless you can verify with doo guys you have a match. Trust me dropping the suspension is worth the trouble for the measurements, doos are really easy to drop. You can use the CB performance drop brackets, but I think the rear shaft on that skid is 1.5" dia, it was on the SC10III anyway. So you have to have someone mill the slot larger in the CB bracket if you use it and it works great. Let me know if you need anything else, I can get you pictures if you need them.
Click to expand...
I just picked up an 04 SC3 from a rev with the front tabs. I’m looking to install into my 04 viper and have no idea where to start. Do you have the measurements to get me started? Thanks!
 
You must log in or register to reply here.


Back
Top