03viperguy
Moderator
looking good!
BigTimeFarmer said:Wow, those valves are clean enough to eat off of!!! wanna do mine too?
A couple of bucks said:With all of the 'female' accent on this warhorse, she'll need something like this to pull it all together.
super1c said:Bring em over, running a spring special. Beer a piece!!
super1c said:Bring em over, running a spring special. Beer a piece!!
BigTimeFarmer said:but than again running a yamaha repair business would be pretty tough so i think i'll focus on AC's and Poo's.
BETHEVIPER said:you will want to change that wire to the starter, it should not run under the drag link. When you turn the sled that link gets closer to the hump, it might chafe. It should run along the motor above the link. There should be a bendable metal bracket that will bolt on at the pump cover and hold it tight, it then curves down to the starter.
It might be ok the way it is but someday when you hit the switch, you might smell smoke. also, the wire on most i have had apart go through the center of the mag side bracket and is tied off to it so that end wont chafe.
good luck, great build. Once in a while I get my daughter in the gararge when she isn't dancing, teaching dance, watching dance or thinking about dance.
BigTimeFarmer said:thanks for the offer but after last night i'm thinking about going into the snowmobile repair business. mother nature has pretty much shut down any chance of corn going in the ground for a while. at least i'll have beer to drink if i can find enough dirty power valves! lol. but than again running a yamaha repair business would be pretty tough so i think i'll focus on AC's and Poo's.